, ,

Shure SM7dB Podcast Set


  • 2x SM7dB dynamic broadcast microphone
  • Built-in preamp with +18 or +28 dB gain
  • True bypass for the classic SM7B sound
  • Cardioid, 50 Hz to 20 kHz
  • Bass roll-off and presence boost switches
  • Table stands, windscreens and XLR cables included

€65,00 /Shoot Day

1 Day
2 Days
3 Days
4 Days
5 Days
1 Week
€65,00
€123,50
€175,50
€221,00
€260,00
€318,50
+ 10% discount for online bookings · Prices excl. VAT and insurance

To the description ↓

Shure SM7dB Podcast Set Specs
Microphone
Type Dynamic (moving coil)
Polar Pattern Cardioid
Orientation End address
Frequency Response 50 Hz to 20 kHz
Sensitivity (1 kHz) Bypass: -59 dBV/Pa, +18 dB: -41 dBV/Pa, +28 dB: -31 dBV/Pa
Output Impedance 150 Ω (bypass), 27 Ω (preamp)
Equivalent Noise -130 dBV (A-weighted, typical)
Preamp and Controls
Preamp Gain +18 dB / +28 dB, true bypass
Switches Preamp gain/bypass, bass roll-off, presence boost
Phantom Power 48 V, max. 4.5 mA (needed for preamp only)
Physical
Connector XLR 3-pin male
Mount Yoke with captive stand nut, 5/8"-27 thread (3/8" with adapter)
Shock Isolation Internal air suspension
Housing Black enamel aluminum and steel
Weight 837 g (per microphone)

Description &In the Case

Description

Record a podcast or an interview with two people on two identical Shure SM7dB microphones. The SM7dB is the well-known SM7B broadcast mic with a built-in preamp: a dynamic cardioid microphone made for podcasts, voice-over and radio. With table stands, windscreens and cables for both mics, this set covers a complete host-and-guest setup.

Built-in preamp

Dynamic mics like the SM7B have low output, so many recorders and interfaces have to add a lot of gain, or you need an external booster. The SM7dB has that booster built in: it adds +18 or +28 dB and is powered by 48 V phantom power from your recorder, interface or mixer. In bypass mode, the preamp is taken out of the circuit entirely and the mic works like a classic SM7B, with no phantom power needed.

Sound and placement

The cardioid pattern rejects sound from the sides and rear, and the internal air suspension keeps handling and table noise out of the recording. Speak directly into the mic from about 2.5 to 15 cm: closer gives more bass, farther away gives less. Two switches on the back shape the sound. Bass roll-off reduces low-frequency hum and rumble, and presence boost lifts the midrange for clearer speech.

Two windscreens per mic

The standard RK345 foam windscreen is meant for general use. The larger A7WS reduces plosives and wind noise further, which helps when people speak close to the mic.

Our rental set

You get two SM7dB mics, each with both windscreens, two Rode DS2 table stands, two XLR cables, two 5/8" to 3/8" thread reducers and a hard case. To use the preamp, connect the mics to a recorder, interface or mixer with two XLR inputs and 48 V phantom power.

In the Case
  • 2x Shure SM7dB
  • 2x Shure RK 345 windscreen
  • 2x Shure A7WS windscreen
  • 2x Rode DS2 table stand
  • 2x XLR3 microphone cable
  • 2x 5/8" > 3/8" reduction
  • Hard case

Don't forget to book a recorder or audio interface with two XLR inputs and 48 V phantom power.

SHOPPING CART

close